What intake manifolds can be used with a Cuda 440-4 shaker???

[CudamanTom]

I'm fixin to add the shaker scoop assembly. I have a torker 2 intake on my 440-4 now which is too tall to use with a shaker as I'm finding out. 

So now I'm in the search for what intake choices I might have or will stock intakes be the only choice?

Thanks for your help.

Tom

[brads70]

When I was shopping for an intake I was told the Holley street dominator was one of the lowest intakes, but I have no idea if it works with the shaker set up?  Works fine with the T/A hood though.

[CudamanTom]

Thank you Brad.

I will look at the height of the Holley street dominator compared to the stock intake.

[anlauto]

I cut about 1 3/4" out of this shaker base to fit the EFI...

Car came with an NOS 383 Shaker base plate too...

[Chryco Psycho]

The Holley Street Dominator is not only one of the lowest ones , it is a top performer too

[brads70]

Thank you Brad.

I will look at the height of the Holley street dominator compared to the stock intake.

If you need any measurements I'd be happy to help. 

[HP_Cuda]

I can tell you for sure an M1 intake won't work.

 

[CudamanTom]

If you need any measurements I'd be happy to help. 

Well Brad, since you brought it up. I would certainly appreciate it if you wouldn't mind taking a measurement. 

Thank you,
Tom

[Strawdawg]

google should bring up some of the magazine comparison tests with some specs but here is what Holley says

https://www.holley.com/products/intakes/single_plane_manifolds/parts/300-14