No lights.

[Cuda_451]

I have headlights, turn signals, hazards, and brake lights but when I have the headlights on my rear light won't show and my front lights won't work at all unless it's with turn signals.

[dodj]

Start with cleaning up the tail light ground. Clean the tail light housing and make sure the light fits snug into it.

[Bullitt-]

double check the fuse with a meter &  that power is getting to the fuse so you'll know which end of the system to be looking at
Also ck that the filament in the bulbs are all good,,,, 2=filaments in each bulb

[Cuda_451]

I have new fuses and bulbs but they work with turn signals and brake lights

[Bullitt-]

Doubt all the bulbs would be bad but NEW don't mean good..  Test voltage at and through the fuse otherwise you don't know which end of the system is faulty 

[Cuda_451]

I'm stuck at softball tournaments right now so I will when I get back

[crackedback]

Check the grounds REALLY well.

I'd put the headlights on a relay set up to remove that load from the rest of your system.  All the other lights performance will usually improve with headlight load removed.

[Cuda_451]

It was doing this before I put headlights in, it's basically one day they worked flawlessly then bam! The next day is nothing except turn signals and brake lights

[Cuda_451]

Where are all my grounds that I can check when I get home? I'm still in Gadsden right now. Just need a check out the grounds and voltage

[Chryco Psycho]

there really never were grounds , just the cast housings have to be able to make it to ground through the paint , you can add ground wires from the housings to a good known ground spot on the body . Start testing for power , you can start @ the light switch & turnsignal plug at the base of the column or  work from the other end tsting for power at the light sockets & working back towards the switches , if you have an Ohm meter you can test the housings to ground on the battery too

[Cuda_451]

What the cast housing? Sorry, I'm illiterate to this lol.. What fuses could I check or would they do anything to this?

[Chryco Psycho]

where the tail& turn signal housing touch the sheet metal body ,if there is paint there is no ground

[Cuda_451]

I have tail lights but no park lights up front. And now my fuel guage don't work