Due to some noise in the rear of the car, I decided to check the axle preload. I found the preload at .016"-.021" while rotating the passenger axle and checking it in three places. I reset it to .006"-.009" while rotating the axle in three places. I assume that this will loosen up a tad over the next couple of drives, so I plan on checking it again.
Note: My FSM shows .008"-.018" and I have read posts showing that people think that is too loose. Some say .005"-.010", so that is what I aimed as a range.
Before I test drive it, I am curious what you guys run.
Thanks
