No Power At Ignition

[DirksCuda]

Im wiring up my 70 Cuda but cant get any power at the ignition. I looked in the manual an it shows a 15 amp breaker an a 30 amp. I know the 30 is for windows an conv top but what is the 15 for which I don't have in my fuse box. Would that have anything to do with no power at the key Thanks Dirk

[70chall440]

No, the power from the ignition is not fused in the box, it uses a fusible link by the starter relay.

[DirksCuda]

Ok I got power at the fuseable link but no power at the key im thinking its something in the fuse box. So do I even need the 15 amp breaker Thanks Dirk

[70chall440]

I am pretty sure its not something at the fuse box, its most likely the connection under the steering column, check the red and brown wires.

[DirksCuda]

Ok I will do that as soon as it cools down a bit. Thanks Dirk

[DirksCuda]

I checked the red an brown at the steering column I got power at red but nothing at brown with the key on or off. What do u think that's at the bigger of the 2 plugs the other one I got power at a black with yellow stripe  Thanks Dirk

[DirksCuda]

What is the brown one for

[70chall440]

Goes to the ignition side (ignition 1) goes to the ballast resistor.

[69bcuda]

Checked the neutral start circuit?

[DirksCuda]

Turned out it was the engine ground wire Thanks Dirk

[70chall440]

  glad you found it.

[DirksCuda]

70chall440 Now its on to putting the glass in. When u put the 1/4 windows in does the track and glass go in first then the regulator or the other way around. There is another track with felt in it where does it go in Thanks Dirk. 

[70chall440]

As I recall, the guides go in first, then the regulator, then the glass.  I will have to research the felt piece, I remember it but cannot recall exactly where it goes.