I'm stumped...how do i remove the drip moulding trim.....

[bs549]

on my '74 Cuda without damaging the trim?

[MEK-Dangerfield]

The trim is 2 interlocking pieces. To get to the screws that hold them on, you need to remove the thick black rubber insulation that the windows slide up onto. I believe you also have to remove the trim pieces from the inside of the car too.

  Mike

[Mopar73340]

Like MEK said, once you remove the weatherstip, you'll figure it out. There are probably a dozen screws under there holding on the channel for the weatherstrip and then after you get that off you will see more screws holding on the moulding.

[pettybluecuda]

hello,
It helps once you pull the screws to heat it up a little with a heat gun or your wife hair dryer. Not a torch! lol there rather simple to take off, just pull the weather strip back real slowly a little at a time be sure not to tare it, then theres a bunch of screw holing the inner on then the drip rail will have some screws on it also that you will have to pull the just heat it up a little and carefully pull the drip rail off, be sure not to twist it or bend it!
good luck,
Jesse
 P.S. stop by sometime cudaregistry.com