Does anyone have bolt specs for.......

[moparnut]

I was wondering if anyone has bolt specs(to buy at a hardware store)for flywheel,pressure plate and 4 speed tranny bolts ect??
thanks

[tactransman]

Not sure of the thread pitch or size but definitely everything GRADE 8. Chryco can probably help you on that.

[ShelbyDogg]

All grade 8 from ACE Hardware for the bellhousing and tranny. Speed shop or Mancini for flywheel bolts. Make sure that the flywheel bolts don't go through the crank and rub the block. If you have to, grind then a little shorter.

 Make sure that the bolts don't bottom out before pulling the trans in tight. Check the hole depth with a nail then compare the bolt engagement, if it's not the same, clean out those threads with a tap. Use the longest bolts possible without bottoming.

[moparnut]

THanks ROb,I guess i can pull one of the bolts from the tranny on my chally to match them up at the hardware store,along with the bell bolts

[ShelbyDogg]

Just take that Bellhousing into the store with you. The 4 trans bolt holes are there, and 2 bell housing bolts halfway down are threaded also.  The trans is about 1/2" thick at it's ears.  Get some good lock washers with the bolts.

[moparnut]

Just take that Bellhousing into the store with you. The 4 trans bolt holes are there, and 2 bell housing bolts halfway down are threaded also.  The trans is about 1/2" thick at it's ears.  Get some good lock washers with the bolts.

DOH good idea,lol.At least someone's thinkin,I'm gettin Old
thanks

[Chryco Psycho]

I use Arp flywheel bolts ,7/16 X 1" with fine thread is what you need , in a package of 6 
4 bolts- 7/16 X 1.5" coarse thread for the tranny to bel
4- 3/8" X 1.25" long coarse thread & 2- 7/16 x 2"  to bolt the bel to the engine

[moparnut]

thanks