News:

  • Home
  • Help
  • Chat
  • Login
  • Register

    • « previous next »
    Pages: [1]

    Author Topic: Engine to transmission bracket?  (Read 890 times)

    Offline Jacksboys

    • Sr. Resident
    • ******
    • Posts: 5540
    • Here Since 08/28/06 GEORGIA
    Engine to transmission bracket?
    « on: February 03, 2007 - 01:04:29 AM »
    Is there a engine to transmission bracket for the SB 833OD version?

    If so, does anyone have a pic you can show? 

    Also is this a critical piece?
    Logged
    1971 Dodge Challenger:  360/904/3.23
       
    Success is the maximum utilization of the ability that you have. - Zig Ziglar


    Offline Moparal

    • Permanent Resident
    • *******
    • Posts: 13085
    Re: Engine to transmission bracket?
    « Reply #1 on: February 05, 2007 - 05:50:26 PM »
    I am not sure, but I don't think so. I have never seen one in all my years. On the automatics, that's the bar that goes from the side of the block to the front of the tranny shield? On the standards, there is no place I have seen where it would mount. The flywheel cover bolts curve under it on the bottom.
    Logged

    Offline Jacksboys

    • Sr. Resident
    • ******
    • Posts: 5540
    • Here Since 08/28/06 GEORGIA
    Re: Engine to transmission bracket?
    « Reply #2 on: February 06, 2007 - 09:38:52 AM »
    Quote from: Moparal on February 05, 2007 - 05:50:26 PM
    I am not sure, but I don't think so. I have never seen one in all my years. On the automatics, that's the bar that goes from the side of the block to the front of the tranny shield? On the standards, there is no place I have seen where it would mount. The flywheel cover bolts curve under it on the bottom.

    Thanks Moparal.  I knew the autos had one but we were not sure about the manuals.
    Logged
    1971 Dodge Challenger:  360/904/3.23
       
    Success is the maximum utilization of the ability that you have. - Zig Ziglar
    Pages: [1]
    « previous next »