Small block valve train alignment issue.

[torredcuda]

I have stock 915 heads with Crane ductile iron adjustable rockers and while assembling things noticed that some of the rocker tips don`t align in the center of the valve tip.The rockers are held out against the stock spacers using springs in between them and I`m wondering if they could be more centered using spacers instead of the springs.I`ve been running them this way  for years but am I doing any damage or is it no big deal?Are there spacers available or do I need to custom make them?I noticed a pic of the stock 273 setup and they use spacers.   

[ntstlgl1970]

Can you take a picture? Maybe the spacers got mixed up if you had the rockers off the shafts?

[torredcuda]

I`m charging the camera batteries and i`ll get a pic up as soon as I can.There are no spacers provided with the Crane set,just springs to hold them out against the factory hold downs.

[torredcuda]

Harland Sharp sells shims in different widths under repalcement components.Wonder if they will work for me?
http://www.harlandsharp.com/

[Chryco Psycho]

Mopar sells packs of shims as well if you want to remove the springs entgirely you need a spacer ring the correct width 

[LAA66]

 I made custom spacers from aluminum.Trouble is after a while the soft metal wore. Recently installed valve spring shims to compensate w/0.875 ID. Use a hardened material if you go the positive spacer route.

 

[torredcuda]

I`m ordering a selection of spacers from Harland Sharp and will custom grind them to the sizes I need for alignment.