11inch clutch cuda????

[cuda44440]

I have a 11inch clutch set and bellhousing. Will this fit in a 1970 cuda? Any clearence problems for the bell housing and firewall?   As far as I know only 10.95 bellhousing and clutch was factory. This is going to be a 440 six pack 833 18 spline car.
Also the flywheel has some small heat cracks after machining it. Is this still ok to run???

[Chryco Psycho]

Welcome Cuda44440  
the 11" clutch will fit just fine , the belcrank may be different though if the belhousing is wider at that point
 most flywheels have some small cracks in them , usually this is not a problem but if you are worried about it you can get new flywheels or even steel race flywheels which are far stronger , I guess it depends how hard you intend to drive the car .

[cuda44440]

Thanks for  the info!
I am not sure about what  a belcrank is.
I also have a 10.95  bell and flywheel  I might  just use it but  bigger is better.

[Chryco Psycho]

really no difference between the 10.95 & 11" , most of the 11"  stuff costs more though ,
 Bel crank = Z bar, pivot shaft between the frame & bell for the clutch linkage