rear wing diminsions please....

[burrpenick]

I'm planning on using one for my 72, can someone provide the diminsions of the originals 70-71? Thanks,

George in Tallahassee

[Super Blue 72]

Are you looking for the physical length and width of the wing or for the measurements to drill the trunk lid for installation? 

[Moparal]

If you have a yearone catalog, I believe it had a diagrahm on where to drill the holes. Most of the time, when you buy a wing the diagrahm is in the box with it.

[burrpenick]

I need the actual diminisions of the wing itself, not the holes diagram. I'm looking at a generic, if its close, I may go for it. This one is 48" long has ajustable hdight and rectangular ends. May not be perfect, but affordable...that is if its long enough. My trunk lid is about 48 I think but cant remember if the spoiler is suppost to stick over that edge.

[4Cruizn]

I think it would look better with no wing at all.    

[Super Blue 72]

Sent ya a PM with the dimensions of a '71 Go-Wing and my  . 

See this pic, if it shows up!  1970 style.

I took measure ments of my '71 wing, which may be different than the '70 style.

It the widest: 59.5", at the narrowest=55", at the midpoint=57.5".  This is the "gull wing" style that tapers back to a point.

[burrpenick]

Yep, the local one was way too short as I expected. I'm still in the hunt, so let me know if you have any leads.

[Moparal]

Josh's muscle cars sells the whole kit for like 130 bucks or the concourse show one for around 395

[burrpenick]

Thanks, but Josh is up to  $205 or 170 w/o the underside bracket. Thats not too bad, not sure if the ones on Ebay included that bracker or not for $179

George

[Super Blue 72]

How about MAS fiberglass?  They advertise in Mopar Collector's guide and seem reasonable?  No website though... 

[burrpenick]

[color=orange]THANKS![/color][/glow]