440 Hood emblems - I'm having size issues

[DAYLEY/CHALLENGER]

Measured mine tonight.  5 7/8" and two pins...........

[Chryco Psycho]

the 440+6 emblem for the Chall was bigger & may have used 3 holes so the holes could be original , the charger 440 mag emblems I believe fit where the 6 pack emblems fit , the 3830440 were much smaller on the Chall than the Charger

[Madmax440]

I have also run into a similiar dilemna. I am changing my 440 Magnum (two pins, two holes in the hood) and the 440 Six Pack emblems that I have have 3 pins.

Are the smaller two pin insignas correct for the Challenger correct than

[Madmax440]

After a little research it appears as if I have 72 B-Body emblems. It didn't show number of pins on any of them, but it was only the 72 B Body that noted that it would need 3 retainer clips. 

[Chryco Psycho]

the small 2 pin emblems are correct for chall until you had the 6 pack then it had the larger 3 pin emblem to my knowledge

[Madmax440]

Does anybody know where I can find the 440 Six Pack Emblems with double stick tape. I don't look forward to drilling more holes in my hood. 

[ted]

cut the pegs off and use the tape