If you want the contact info for this motor let me know asap:
Quoted:
1967 383 big block. The engine was pulled 2 weeks ago and ran great. Had alot of horsepower. I pulled it because I am putting in a 440 six pack so I no longer need this engine. In 2007 I put a new Edlebrock RPM performer cam and lifter set in it. New push rods, rocker arms, rocker shaft and a new double roller timing chain. The distributor is 2 years old and is an electronic distributor. I had to get a different one for my 440 so it goes as well. I am including the original 2 barrel intake manifold and carb. This is not the one I was just using. I did have it on the car 3 years ago but I am sure the carb will need to be rebuilt. I am also including the water pump, and pulley and the crank pulley. You are not getting the water pump housing, just the pump. It is 2 seperate units and I need the housing. The Oil pan is a little rough and probably should be replaced. I am including a new chrome timing chain cover along with the original cover.
Also included: Edlebrock intake with a holley 600 carb.
Other notes: I changed the accelator pump and the jets and it ran great. You will get almost a complete engine ready to go that needs no rebuild. I had the heads off when I put the cam in last year and the cylinders looked great. I used an inside mic and checked them for roundness and compaired size and they were all equal. I can't remember if they were 3.252 or 4.252 inches across but I do remember the .252 number and it was the same on all of them.
Price $850 crated!
