question about my ralley gauges

[Katfish]

These metal re-pops come in a flat sheet, but it's fairly simple to mold them to your plastic bezel. You do need to remove your old metal face plate first. I just used some general adhesive and a couple of clamps to hold it on overnight.

  Mike

Isn't the factory 1 held on with metal tabs that bend around the edges?  I was hoping the repop was the same?  It worries me if you have to glue it.  What if you ever need to remove it for some reason?

Thx

[MEK-Dangerfield]

Isn't the factory 1 held on with metal tabs that bend around the edges?  I was hoping the repop was the same?  It worries me if you have to glue it.  What if you ever need to remove it for some reason?

Thx

The re-pops do have the tabs that bend around the edges. The originals were glued on too, as you will find out if you remove them.


  Mike

[Katfish]

Thanks for the heads-up.  Where did you buy yours?

[MEK-Dangerfield]

Thanks for the heads-up.  Where did you buy yours?

P.G. Classics. They sell on E-Bay. I think their username is Eparts4cars.  I'm not sure if anyone else sells them.