This was a set of 4 pieces of replacement trim, I kept the upper and lower straight pieces and the other guy took the eyebrows. Word is that my straight sections have a bow in them which appears to be expansion from the polishing process, and don't follow the line of the grill very well at all (they believe it would be under some tension if fitted and could break off the plastic tabs. The eyebrow pieces apparently need quite a bit of bending and work to make them fit, and were too short by 10mm on the top (to meet up with the original upper straight section) and had rolled edges rather than the sharp edges of a factory piece. he also reported that the finish was nowhere near as good as the factory finish. Will keep you posted on progress and results.