Fastener spec

[ChallengerHK]

Does anyone know the spec for the fasteners that hold the fuel filler grommet to the trunk floor? 73 Challenger, if it makes a difference.

[72hemi]

I know it's a phillips head screw that is I think about a 1/4" long.

[Topcat]

I got the spec book. gimme a few to find it.

[Topcat]

Heres how it reads:

(4) #10 -14 x .60" lg. phillips drive screws with captive washer. silver zinc finish

A. .60 from back of washer to tip
B. .50 Width of head on washer (not the phillips screw)
C. part # 6026092

* This fastener is used on various other components. i.e., vapor seperator, seal, washer bottle,  etc.

[72hemi]

Hey where do you get spec books at?

[Topcat]

its this place.

http://www.mmcdetroit.com/Testimonials/

[RusTy/SE]

Yes that's the place

http://www.mmcdetroit.com/Market_Place/

[72hemi]

Thanks.

[ChallengerHK]

Thanks, guys.