fender mounted turn signals

[dwbiggs]

When I got my car painted I took apart the front end...when I went to put it back together I didn't think about the signal lights and now I can't figure out how the pigtails feed through to the harnass.  When I look through the hole where they mount there is nowhere where I can see to feed the pigtail through to the main harness.  Anyone have any ideas, or do I have to take the grill off to do it?

[Chryco Psycho]

there shoud be a single pin connecter with the connector for the side marker light , if it is routed correctly it will reach

[GoodysGotaCuda]

yep mine were between the grille and the radiator support on each side, near the headlight buckets. the haness will be female single plugs, male side is on the light assembly itself

[dwbiggs]

My problem is feeding the wire through to the connection.  I can't seem to find a way through the hole on the fender down to the connection in the harness.  There is a floor if you look through the hole on the fender and I can't see where to feed it.

[Chryco Psycho]

there should be a small hole to route the wiring through into the wheelwell

[dwbiggs]

Thanks, I'll take another look.

[Chryco Psycho]

look inside the wheel well , there should ba a small hole approx 1" for the wiring to go through

[dwbiggs]

look inside the wherel well , there should ba a small hole approx 1" for the wiring to go through

Thanks!

[Chryco Psycho]

I assume you found it ??

[Black340]