RMP Airgap pics for 340?

[mikerallye]

Anyone got any pics of a 340 with an RPM Airgap intake? I am needing some ideas on routing water hoses and sending units. thanks   

[PlumCrazyChris]

Here's a pic of mine, but it may not show you what your looking for.  I have other pics of it installed, but they are to big to upload.  Let me know if you want me to send any to you directly.  By the way, an air gap intake on any size smallblock will look exactly the same.


Good luck,
Chris

[422STROKER]

I got this one for now, I think i posted it somewhere else for you.

Tom


By tdavist, shot with DSC-P72 at 2008-05-02

By tdavist, shot with DSC-P72 at 2008-04-26

By tdavist, shot with DSC-P72 at 2008-04-20

[mikerallye]

Thanks gentlemen,  I now realize that you must use a 3/8 pipe thread tap to enlarge the heater hose fitting on the intake.   

[422STROKER]

I didn't enlarge anything? 

What size hoses You running?

Unless you need to use the factory pipe nipple you can get a brass hose end and it fits fine.

Tom

[mikerallye]

Facing the engine: the heater hose hole on the intake was only 1/4 in . I opened up to 3/8 pipe thread and put the standard Chrysler nipple in it and used 5/8 hose; I think. I used the hole on the rt for a mechanical gauge. thanks