News:

  • Home
  • Help
  • Chat
  • Login
  • Register

    • « previous next »
    Pages: [1]

    Author Topic: Front Bearing Retainer  (Read 864 times)

    Offline vinb

    • Resident
    • *****
    • Posts: 2163
    Front Bearing Retainer
    « on: September 28, 2008 - 10:55:56 AM »
    4spd info,
    Can I bolt up a 4.807 bearing retainer to a 4spd that has a 4.354?
    Reason being I'm probably going to put a Lakewood scatter shield in the Cuda.
    The front hole is 4.807 on the shield..
    Thanks Guys...
    Logged


    Offline Chryco Psycho

    • Administrator
    • C-C.com Guru
    • *****
    • Posts: 36620
    • 70 Challenger R/T SE 70 tube Chassis Cuda now sold
    Re: Front Bearing Retainer
    « Reply #1 on: September 28, 2008 - 11:37:06 AM »
    no , the bolt pattern is differnet between the two , I have seen some spacer rings made to increase the diameter of the small 4.35 retainer though
    Logged

    Challenger - You`ll wish You Hadn`t

    Offline vinb

    • Resident
    • *****
    • Posts: 2163
    Re: Front Bearing Retainer
    « Reply #2 on: September 28, 2008 - 12:50:54 PM »
    I kind of figured that because of the bolt pattern..
    Thanks CP....
    « Last Edit: September 28, 2008 - 03:25:18 PM by vinb »
    Logged

    Offline vinb

    • Resident
    • *****
    • Posts: 2163
    Re: Front Bearing Retainer
    « Reply #3 on: September 29, 2008 - 05:24:30 PM »
    OK , my next question is who or where can I get a spacer??
    Anyone - Anyone.........
    Thanks Vin............
    Logged

    Offline Chryco Psycho

    • Administrator
    • C-C.com Guru
    • *****
    • Posts: 36620
    • 70 Challenger R/T SE 70 tube Chassis Cuda now sold
    Re: Front Bearing Retainer
    « Reply #4 on: September 30, 2008 - 03:06:32 AM »
    I made the last one from a piece of tube
    Logged

    Challenger - You`ll wish You Hadn`t

    Offline Moparal

    • Permanent Resident
    • *******
    • Posts: 13085
    Re: Front Bearing Retainer
    « Reply #5 on: September 30, 2008 - 08:06:23 AM »
    Lakewood has them. Theyy usually come with the lakewood bell housing when you buy their kit. I have one on my 4 speed  trans to fit my bb bellhousing
    Logged

    Offline vinb

    • Resident
    • *****
    • Posts: 2163
    Re: Front Bearing Retainer
    « Reply #6 on: September 30, 2008 - 06:30:22 PM »
    I called Mcleod this afternoon and they said they only make them for Chevy's & Ford's sizes..4.850 & 4.680..
    I'll call Lakewood tomorrow when they open...
    Thanks
    Logged
    Pages: [1]
    « previous next »