Anyone have a measured photo of fender turn signals on a Challenger?

[PlumCrazyChris]

I need to drill the holes on my fenders for the turn signals before sending it to the body shop, but have somehow misplaced the measured diagram I had that shows distances from the holes, to the front and side body lines.   Also, what diameter holes if you know.

Thanks,
Chris

[Cuda Cody]

I'm not sure what area you need a measurement of?  Post a picture of the area you need and I will measure it for you and post the results with a picture.

[PlumCrazyChris]

Thanks Cody, the measurements I'm talking about is from the edge of the front of the fender (not trim) to the holes  and   the measurement from the inside edge of the fender where it meets the hood.

I don't know if that makes any sense, I'll try to find a picture. 

It actually doesn't HAVE to be to the holes, measurements to the actual turn signal would be good enough, I can figure out the holes from there. 

[MEK-Dangerfield]

Are you talking About the turn signal indicators on the fenders?

This is my 70, but in the pics, I'm measuring for the hood pins.  It can give you an idea though.


  Mike

[PlumCrazyChris]

I think those will do it, thanks a lot MEK!  Beautiful color on your car too.

Thanks again,
Chris

[Cuda Cody]

Looks like Mike has you covered!