Where does this part go??

[kmyles]

 
Thanks for the help!

[Moparal]

Bolts onto the automatic trans tail shaft to hook up the floor shift slapstick linkage

[MEK-Dangerfield]

This should help...


By the way, congrats on the photobucket account.   

[brads70]

  I just realized I need that part I think? Alan do you have that too?

[burdar]

The bushing on the end is usually worn out.  You can get a new one from R/T Specialties.  Also, on my car, the shaft that rides in that bushing was worn.  If yours is, you'll have to have someone weld up the bad spot and grind it back down to size.  If you don't, the car may not go completely into gear.  My car didn't want to fully engage PARK.   

[kmyles]

Thanks guys

[kmyles]

And what about the oil pressure sensor. What type of connector hooks up to this?    I thought I had the right one but it doesn't fit.

Any pics would be great...

[Moparal]

I just realized I need that part I think? Alan do you have that too?

Yes  I have included that part for you.

[brads70]

Yes  I have included that part for you.

Thanks Alan! Didn't you say I needed something for this set up? Don't mind the questions I'm learning!

[dodj]

And what about the oil pressure sensor. What type of connector hooks up to this?    I thought I had the right one but it doesn't fit.

Any pics would be great...

Just a regular female spade connector.

[Chryco Psycho]

you should havae a grey wire with the spade connector on it