Need a picture of end of 1/4 panel - valance for a Cuda

[AZDAN]

 I need a couple of pictures of how the end of the quarter panel meets up with valance panel. The edge of the q-panel or end of it. need a picture of how the panel meets up with the trunk drop offs . I have a patch panel and i know it needs to be tweaked.  Should the Q-panel be flanged for the valance to fit over it? How far below the end of the trunk extension does the quarter panel extend down?
 Thanks Dan

[e-tek]

I have a 74 Challenger, but am quite sure the quarters and drop offs are mated the same way.  Maybe someone can chime in for sure. There's no flange required for the drop off and quarters sort of "lay on top of one another, mating along the lower edges. The valnce and quarters bolt togther with three tabs. If someone doesn't post cuda pics for you , i'll post mine - i just did my quarters. Good luck!