Hey from TN
I need some advice on an issue that popped up today. I have just installed my new setup from FBO (Great Company).
I had been going thru the checks and setting the recommended numbers when I started getting a weird starting sequence.
I would turn the ignition as usual but instead of an instant start I got a delay before the starter would engauge. It started but the delay caught me off gaurd so I immediately turned it off to find out that the solenoid/starter (New) was still spinning.
I did the this 5 times with the delay occurring 3 out of the 5. The 2 remaining were normal starts. The good thing is that it started everytime.
Question: Could anything I installed today cause this issue or could my adjustments during the install interfer?
Any help would be helpful.
Installed:
Distributor
Coil
ECU
Ballast Res
(A688 Kit) (Thanks Don
)
