Author Topic: geting it started  (Read 957 times)

Offline HAWS

  • Jr. Member
  • **
  • Posts: 13
geting it started
« on: September 07, 2009 - 07:57:33 PM »
Hi, I'm new to this web site. I have a 70 cuda 340 six pack. I just got the car, and I'm having trouble starting it.  What I mean is, seems like I always flood it . Is there a trick to starting those six pack engines? Any advice would help thanks...Harry




Offline Moparal

  • Permanent Resident
  • *******
  • Posts: 13085
Re: geting it started
« Reply #1 on: September 07, 2009 - 08:02:44 PM »
Is the choke stuck closed?  Shouldnt be a problem if gas isnt leaking past the floats or the choke stuck. Be careful of a backfire, but have you tried holding the throttle to the floor to clean it out?

Offline 73Chally

  • Resident
  • *****
  • Posts: 2381
Re: geting it started
« Reply #2 on: September 07, 2009 - 08:06:50 PM »
Have you checked for spark from the coil?

wagesofsin

  • Guest
Re: geting it started
« Reply #3 on: September 07, 2009 - 08:26:27 PM »
be aware , the outboard carbs do not have anything to do with initial startup, they are vacuum operated, and only play into w.o.t.
make sure you are not stuck open on the outboards.

just a toss of my  :2cents:

Offline dodj

  • Sr. Resident
  • ******
  • Posts: 6197
Re: geting it started
« Reply #4 on: September 07, 2009 - 08:59:40 PM »
I have a 70 cuda 340 six pack.
Is it an AAR? Either way, a nice car to start out with.  :wow:
Scott
1973 Challenger  440 4 spd 
2007.5 3500 6.7 Cummins Diesel, Anarchy tuned.
Good friends don't let friends do stupid things. ........alone.

Offline Chryco Psycho

  • Administrator
  • C-C.com Guru
  • *****
  • Posts: 36620
  • 70 Challenger R/T SE 70 tube Chassis Cuda now sold
Re: geting it started
« Reply #5 on: September 07, 2009 - 09:13:32 PM »
there are a lot of possibilities here
start with checking the float levels ,
 make sure the choke is only closing lightly or not even all the way .
 is it boiling the fuel when you shut it down , possibly you need to block the heat crossover port in the intake
 just push the pedal 1/2 way down before you start it cold to set the choke
 & yes the outboards do play a roll , they have mixture screws in the base plate also

Challenger - You`ll wish You Hadn`t