Author Topic: DEFINITION OF ACCELERATION  (Read 1017 times)

Offline HemiDog

  • Sr. Member
  • ****
  • Posts: 1384
  • Do not Assume!
    • Hemi Dog
DEFINITION OF ACCELERATION
« on: December 16, 2009 - 12:00:05 PM »
I just received this as a email from a buddy and thought it was a pretty cool read.  Thought I would share:
 
 One top fuel dragster 500 cubic inch Hemi engine makes more horsepower
 than the first 4 rows of stock cars at the Daytona 500.
 
 It takes just 15/100ths of a second for all 6,000+ horsepower of an NHRA
 Top Fuel dragster engine to reach the rear wheels.
 
 Under full throttle, a dragster engine consumes 1-1/2 gallons of nitro
 methane per second; a fully loaded 747 consumes jet fuel at the same rate
 with 25% less energy being produced.
 
 A stock Dodge Hemi V8 engine cannot produce enough power to drive the
 dragster's supercharger.
 
 With 3,000 CFM of air being rammed in by the supercharger on overdrive,
 the fuel mixture is compressed into a near-solid form before ignition.
 
 Cylinders run on the verge of hydraulic lock at full throttle.
 
 At the stoichiometric (stoichiometry: methodology and technology by
 which quantities of reactants and products in chemical reactions are
 determined) 1.7:1 air/fuel mixture of nitro methane, the flame front
 temperature measures 7,050 deg F.
 
 Nitro methane burns yellow.. The spectacular white flame seen above the
 stacks at night is raw burning hydrogen, dissociated from atmospheric water
 vapor by the searing exhaust gases.
 
 Dual magnetos supply 44 amps to each spark plug. This is the output of
 an arc welder in each cylinder.
 
 Spark plug electrodes are totally consumed during a pass. After
 halfway, the engine is dieseling from compression, plus the glow of exhaust
 valves at 1,400 deg F. The engine can only be shut down by cutting the fuel
 flow.
 
 If spark momentarily fails early in the run, unburned nitro builds up in
 the affected cylinders and then explodes with sufficient force to blow
 cylinder heads off the block in pieces or split the block in half.
 
 In order to exceed 300 mph in 4. 5 seconds, dragsters must accelerate an
 average of over 4G's. In order to reach 200 mph (well before half-track),
 the launch acceleration approaches 8G's.
 
 Dragsters reach over 300 miles per hour before you have completed
 reading this sentence.
 
 Top fuel engines turn approximately 540 revolutions from light to light!
 Including the burnout, the engine must only survive 900 revolutions under
 load.
 
 The redline is actually quite high at 9,500 rpm.
 
 Assuming all the equipment is paid off, the crew worked for free, and
 for once NOTHING BLOWS UP, each run costs an estimate $1,000.00 per second.
 
 The current top fuel dragster elapsed time record is 4.428 seconds for
 the quarter mile (11/12/06, Tony Schumacher, at Pomona , CA ). The top speed
 record is 336.15 mph as measured over the last 66' of the run (05/25/05 Tony
 Schumacher, at Hebron , OH ).
 
 Putting all of this into perspective:
 
 You are driving the average $140,000 Lingenfelter 'twin-turbo' powered
 Corvette Z06.  Over a mile up the road, a top fuel dragster is staged and
 ready to launch down a quarter mile strip as you pass. You have the
 advantage of a flying start. You run the 'Vette hard up through the gears
 and blast across the starting line and pass the dragster at an honest 200
 mph. The 'tree' goes green for both of you at that moment.
 
 The dragster launches and starts after you. You keep your foot down
 hard, but you hear an incredibly brutal whine that sears your eardrums and
 within 3 seconds, the dragster catches and passes you. He beats you to the
 finish line, a quarter mile away from where you just passed him.
   
   Think about it, from a standing start, the dragster had spotted you 200
 mph and not only caught, but nearly blasted you off the road when he passed
 you within a mere 1,320 foot long race course.
 
 ... and that my friend, is ACCELERATION!





Offline Oldschool

  • Administrator
  • Permanent Resident
  • *****
  • Posts: 13195
  • Member Since 9-05-06
Re: DEFINITION OF ACCELERATION
« Reply #1 on: December 16, 2009 - 12:04:38 PM »
I want one....     :ylsuper:    :burnout:    :bigsmile:   
Ken  --  In Georgia

MOPAR-------"Built To Run------Here To Stay"

Offline the_engineers

  • Resident
  • *****
  • Posts: 2639
  • Cheap, fast, reliable...pick 2
Re: DEFINITION OF ACCELERATION
« Reply #2 on: December 16, 2009 - 12:09:41 PM »
Assuming a Top Fuel dragster leaves the line with the engine at the 9500 rpm redline, the entire race only takes 700 engine revolutions.  More likely, the total revolution count is under 500 to keep from shocking the tires.
Brooks

1971 'Cuda 360
2004 Infiniti G35 6-spd Coupe
2001 Toyota Solara Convertible
2002 GMC Savana 1500 Explorer Hightop Conversion
1972 Dodge Dart Swinger...keeping the Slant.  Rocking the turbos.

Offline quapman

  • Resident
  • *****
  • Posts: 2350
    • Auto-Grip on Facebook
Re: DEFINITION OF ACCELERATION
« Reply #3 on: December 16, 2009 - 07:43:29 PM »
Can youuuuu dig it?  :2thumbs:
My name is Steve and I'm addicted to Challengers...


Offline bb71challenger

  • Sr. Resident
  • ******
  • Posts: 6549
Re: DEFINITION OF ACCELERATION
« Reply #4 on: December 16, 2009 - 07:56:19 PM »
That information is just awesome!!!!!!    But it still peeves me to see TOYOTA or FORD on the valve covers  :swear:
1971 Challenger (OO==== ====OO) getting close!
1970 Challenger (OO########OO) long ways off
*Brett*

Offline Super Blue 72

  • Permanent Resident
  • *******
  • Posts: 12711
  • "Big 'n Little" Member since 8/9/05
    • Phil's Super Blue '72
Re: DEFINITION OF ACCELERATION
« Reply #5 on: December 17, 2009 - 09:38:55 AM »
 :faint:
1972 Dodge Challenger Rallye 340, AT, Code TB3=Super Blue, SBD=8/17/1971.  Yes, a Rallye without the fender louvers from the factory because of the body side molding option.

Pic #2 and 3 of my ARII 1/24 scale model car 

Phil in New England-Massachusetts  Always thank God for what you have!

http://www.cardomain.com/ride/456046/1972-dodge-challenger

Offline cwestra

  • Sr. Member
  • ****
  • Posts: 1120
Re: DEFINITION OF ACCELERATION
« Reply #6 on: December 17, 2009 - 10:08:02 AM »
Good read.  Thanks for sharing it.
Corey - in Northern Indiana

Offline dutch

  • Sr. Resident
  • ******
  • Posts: 6944
Re: DEFINITION OF ACCELERATION
« Reply #7 on: December 17, 2009 - 10:25:38 AM »
this was posted by cp e little while ago...  still a great read...  :ylsuper:
*** Bart ***

Offline dodj

  • Sr. Resident
  • ******
  • Posts: 6197
Re: DEFINITION OF ACCELERATION
« Reply #8 on: December 17, 2009 - 11:09:48 AM »
 :wow:

(Hemi's always beat Corvettes)
Scott
1973 Challenger  440 4 spd 
2007.5 3500 6.7 Cummins Diesel, Anarchy tuned.
Good friends don't let friends do stupid things. ........alone.

Offline MOPAR FANATIC

  • Resident
  • *****
  • Posts: 4250
Re: DEFINITION OF ACCELERATION
« Reply #9 on: December 17, 2009 - 06:22:19 PM »
Thanks for posting,yup,been nitro'd many times at the races.
gotta  love it.....  :cheers:
71 Challenger 340 a/t
2013 Plum Crazy Hemi R/T 6SPD

Offline 72rtchallenger

  • Sr. Member
  • ****
  • Posts: 1734
  • 72 to 70 clone
    • cardomain
Re: DEFINITION OF ACCELERATION
« Reply #10 on: December 17, 2009 - 06:51:41 PM »
very nice read but more fun to watch  :cheers:
72rtchallenger
my challengers restro at http://www.cardomain.com/ride/399010
what happens in the garage
stays in the garage