8 3/4 rebuild ?

[rb70]

Is there a place where I can get a rebuild kit or a service that rebuilds the rearend?

Should I just do the chunk or should I do everything?

Car sat for 4 years and makes a loud clunk when it goes into gear.  I am going to replace the joints, but was wondering what to do about the rearend.

[Topcat]

Did you by chance see this article?

http://www.moparmusclemagazine.com/techarticles/drivetrain/5148_custom_rear_end_install/index.html

At the very last page it gives 3 references. Many members here and on Moparts contact Drdiff.com.

http://www.doctordiff.com/

He does Mopars

[Katfish]

I'd check the u-joints before you tear it apart.  Loud clunk sounds doesn't seem like a gear problem.

[rb70]

As stated, I am replacing the u-joints, but the car sitting for so long worries me.  I am going to have it out to go over the underbody and figured it was the perfect time to rebuild the unit.

[Topcat]

If a ring and pinion set are in the plans to be replaced, I would recommend Richmond ring and gear. One of the best.

[rb70]

Any place with good service and price?

[Topcat]

Any place with good service and price?

Richmond if you are doing the rebuild.
Call them.


http://www.richmondgear.com/07Apdfs/page5.pdf

[Chryco Psycho]

Dr Diff is good too