Author Topic: Removing Convertible Windshield Moldings (Read 887 times)

lahatte · « **on:** December 25, 2010 - 04:57:30 PM »

Does anyone know the proceedure for removing the stainless moldings from a convertible windshield header without damaging them? I have removed the screws from the right side of the header molding, but it really seems stuck tight. I don't want to bend it trying to get it off.

Also, I haven't yet removed the smaller standard molding that covers the gap around the windshield. Is it held on with clips as with the hardtop model?

Thanks.
Clay

thedodgeboys · « **Reply #1 on:** December 25, 2010 - 07:24:08 PM »

Yes the windshield molding is held on just like the hardtops and must come off first.
There may be some sticky stuff from the windshield holding the frame surround in place so it's best to go slow the sides come off first carefully they bend easily.

lahatte · « **Reply #2 on:** December 25, 2010 - 07:28:54 PM »

Thanks. I've been trying, but so far I can't find any clips with my removal tool (it slides under the molding). The molding on this car is very snug.

Clay

lahatte · « **Reply #3 on:** December 25, 2010 - 07:31:14 PM »

By the way, great looking 70 Challenger. And, do you know anyone with some convertible parts, maybe some sheetmetal too?

Thanks.
Clay

Author Topic: Removing Convertible Windshield Moldings (Read 887 times)

lahatte

Removing Convertible Windshield Moldings

thedodgeboys

Re: Removing Convertible Windshield Moldings

lahatte

Re: Removing Convertible Windshield Moldings

lahatte

Re: Removing Convertible Windshield Moldings