Author Topic: Trunk torsion rod (Read 904 times)

73cudakid · « **on:** January 27, 2011 - 01:23:52 PM »

My 73 barracuda only has one trunk torsion rod. Is this correct? I remember seeing earlier cudas with two.

73yellowfish · « **Reply #1 on:** January 27, 2011 - 02:06:38 PM »

In the same boat....

burdar · « **Reply #2 on:** January 27, 2011 - 02:09:56 PM »

Are there adjustment slots on both sides of the car or just one? The factory went to 1 rod in 71 but went back to two in late 71 or 72. If there are adjustment slots on both sides, you are just missing one of your rods.

mojavered · « **Reply #3 on:** January 27, 2011 - 11:03:52 PM »

My 71 has 1 rod, but I cannot get that thing hooked up. There has to be an easy way.

73cudakid · « **Reply #4 on:** January 28, 2011 - 10:14:07 AM »

There are adjustment slots on both sides. I have seen the later cudas with only 1 rod at the strip, but it seems like it would want to torque the lid just the one way when its being lifted with just one. I have mine in which was a PITA. Just seems like it twists some.

burdar · « **Reply #5 on:** January 28, 2011 - 10:31:06 AM »

When they went to one rod in 71, there were only adjustment slots on one side. Since you have slots on both sides, your car origonally had two.

Author Topic: Trunk torsion rod (Read 904 times)

73cudakid

Trunk torsion rod

73yellowfish

Re: Trunk torsion rod

burdar

Re: Trunk torsion rod

mojavered

Re: Trunk torsion rod

73cudakid

Re: Trunk torsion rod

burdar

Re: Trunk torsion rod