Author Topic: Engine mount question (Read 706 times)

challenger_73 · « **on:** February 28, 2011 - 09:51:07 AM »

Hello all,
I dropped my engine in this weekend and when I went to tighten the engine mounts down the threads ended before the bolt was tightened all the way. Are these bolts supposed to tighten up all the way flush with the mount? I had to put ten washers on the passenger side & 5 washers on the drivers side to accomplish this. If it is supposed to be flush then I was thinking that I need to get bolts with more threads on them. I'm thinking that they are the wrong bolts but they were in my car when I got it. I would rather not leave them like that. Any advice would be appreciated.
challenger_73

Moparal · « **Reply #1 on:** February 28, 2011 - 10:18:51 AM »

They are the wrong length bolts. Those would be ok tho. Pull down tight

femtnmax · « **Reply #2 on:** February 28, 2011 - 10:44:43 AM »

I agree, definitely the wrong bolts.
If you can't find the correct bolts in your area, Steve's muscle cars has helped me alot.
http://www.stevesparts.com/

72rtchallenger · « **Reply #3 on:** February 28, 2011 - 03:12:52 PM »

yes very wrong,,they will be ok but if you just dont like it that way,,u would need new ones

Author Topic: Engine mount question (Read 706 times)

challenger_73

Engine mount question

Moparal

Re: Engine mount question

femtnmax

Re: Engine mount question

72rtchallenger

Re: Engine mount question