Anyone using 3" Stainless X-Pipe Exhaust System???

News:

  • Home
  • Help
  • Chat
  • Login
  • Register

    • « previous next »
    Pages: 1 [2]

    Author Topic: Anyone using 3" Stainless X-Pipe Exhaust System???  (Read 8186 times)

    Offline EbodyPro572

    • "Always restore, NEVER discard!"
    • Jr. Member
    • **
    • Posts: 129
    Re: Anyone using 3" Stainless X-Pipe Exhaust System???
    « Reply #15 on: March 17, 2011 - 09:04:51 PM »
    Hey DodgeBoys, which resonators did you use at the rear?  Did it make a big difference for you?
    « Last Edit: March 17, 2011 - 09:10:40 PM by ProEbody572 »
    Logged
    'ALWAYS Restore.....NEVER Discard'
    73 Challenger; 04 Rumble Bee (Yello, of course); 01 Vehicross (Yello, of course, too); 90 Allante' (not Yello, just red); 79 MGB-V8; 68 Century Resorter;
    73 Marlin Ski (468" Olds) Jet Boat; 06 Harley Fat Boy CVO; 73 Yamaha Golf Cart (Yello, of course); 07 Sears Garden Tractor


    Offline thedodgeboys

    • Resident
    • *****
    • Posts: 3633
    • ''Normal’s Overrated''
      • THE DODGE BOYS
    Re: Anyone using 3" Stainless X-Pipe Exhaust System???
    « Reply #16 on: March 17, 2011 - 10:24:28 PM »
    I don't remember the name of them but it took the drone out of the system.

    I'll look for then name.
    Logged
    Go Fast & Have Fun...
    70 6.1 HEMI 6-speed Drop Top...

    Offline EbodyPro572

    • "Always restore, NEVER discard!"
    • Jr. Member
    • **
    • Posts: 129
    Re: Anyone using 3" Stainless X-Pipe Exhaust System???
    « Reply #17 on: March 19, 2011 - 08:05:33 PM »
    Any benefit of moving the mufflers to the rear of the system just before the tips?  Read somewhere that would improve performance.  Not sure of the sound difference though.  If that can be a 'doable' then what about placing resonators up front just before the X-Pipe with the mufflers in the back.  Or it that stupid???    :dunno:
    Think I've seen it done both ways.  Any opinions???
    Logged
    'ALWAYS Restore.....NEVER Discard'
    73 Challenger; 04 Rumble Bee (Yello, of course); 01 Vehicross (Yello, of course, too); 90 Allante' (not Yello, just red); 79 MGB-V8; 68 Century Resorter;
    73 Marlin Ski (468" Olds) Jet Boat; 06 Harley Fat Boy CVO; 73 Yamaha Golf Cart (Yello, of course); 07 Sears Garden Tractor

    Offline Milkmann

    • Jr. Member
    • **
    • Posts: 98
    Re: Anyone using 3" Stainless X-Pipe Exhaust System???
    « Reply #18 on: March 19, 2011 - 08:17:52 PM »
    Quote from: ProEbody572 on March 19, 2011 - 08:05:33 PM
    Any benefit of moving the mufflers to the rear of the system just before the tips?  Read somewhere that would improve performance.  Not sure of the sound difference though.  If that can be a 'doable' then what about placing resonators up front just before the X-Pipe with the mufflers in the back.  Or it that stupid???    :dunno:
    Think I've seen it done both ways.  Any opinions???

    That is how they left the factory, resonators ahead of the axle and mufflers toward the back. "Back in the day"(1976), my daily driver and only car was a 1973 Challenger 340, PO had replaced the resonators(ahead of the axle)with straight pipes and the mufflers beside the gas tank were still there. It sounded pretty good for what passed the appearance test to be stock exhaust.

    I sorta wanted to reproduce that with my car now, I was unable to locate a muffler that looked like it might put the exhaust tips in the right place. The original tips clamped right onto the muffler outlet.
    Logged

    Offline EbodyPro572

    • "Always restore, NEVER discard!"
    • Jr. Member
    • **
    • Posts: 129
    Re: Anyone using 3" Stainless X-Pipe Exhaust System???
    « Reply #19 on: March 20, 2011 - 01:42:31 PM »
    My rear valance does not have the cut-outs for tips so I'm gonna use the turn-down approach.  Some have said to turn the turn-downs
    very- slightly inward towards each other to help minimize drone & noise.... :clueless:.....don't know if that makes sense.  I'm also using a fuel-cell, so NO gas tank to worry about, so I could even run the tailpipes closer to the centerline of the car.  I've seen this on some cars (not challengers, though!) where the pipes looked pretty slick being centered and only about 18" apart.  Don't know how that would look on a challenger/cuda though.  I'll have to get it up in the air and experiment with location and see how it looks.
    Logged
    'ALWAYS Restore.....NEVER Discard'
    73 Challenger; 04 Rumble Bee (Yello, of course); 01 Vehicross (Yello, of course, too); 90 Allante' (not Yello, just red); 79 MGB-V8; 68 Century Resorter;
    73 Marlin Ski (468" Olds) Jet Boat; 06 Harley Fat Boy CVO; 73 Yamaha Golf Cart (Yello, of course); 07 Sears Garden Tractor

    Offline MEK-Dangerfield

    • C-C.com Expert
    • ********
    • Posts: 20946
    • I don't get NO respect! Member since 1/25/2002
    Re: Anyone using 3" Stainless X-Pipe Exhaust System???
    « Reply #20 on: March 20, 2011 - 04:21:27 PM »
    I don't have the cutouts on my rear valence either. It's just chrome pipes out back. My mufflers aren't insanely loud, so this is perfect. The turndowns will squash the sound some.
    « Last Edit: March 20, 2011 - 05:03:07 PM by MEK-Dangerfield »
    Logged

    Mike

    1970 Challenger - SOLD
    2016 SXT+.  1 of 524 SXT+'s in Plumb-crazy for 2016.
    Pages: 1 [2]
    « previous next »