Crush Can Puller?

[Chryco Psycho]

none I can think of .

[JayBee]

Jay, can you spec the tab length and width? also what's the oval shaped holes spacing? I dont have access to my car to measure that.

willard, the block was a piece of scrap from work with the outer holes close enough so I just had to oval them to make it work. You can probably drill the holes a bit oversize so the bolts will thread in straight. All measurement are approximate but fairly close. Hope this helps.

[challengerx]

I just took two cans off using a regular puller on the outside with long bolts and it was relatively easy, no big pops just came off and there is a master spline on both of my columns.

[willard]

Jay, thanks for the reference picture. I love this board!

[mopar12372]

the puller from autozone was 15.00 fit inside can and worked purfectly

[Katfish]

the puller from autozone was 15.00 fit inside can and worked purfectly

Any chance you have a PN?

[mopar12372]

part#27017 

http://www.autozone.com/autozone/accessories/Tools-Garage-and-Equipment/Steering-Wheel-Puller/_/N-2652?filterByKeyWord=steeringwheel++puller&fromString=search

there where no master splines on my columb , all splines where the same but it was a little hard to get it started after i aligned it as good as i could with the wheels pointing forward  . the columb has never been removed so it is the origional.