News:

  • Home
  • Help
  • Chat
  • Login
  • Register

    • « previous next »
    Pages: [1]

    Author Topic: RPM SB intake  (Read 592 times)

    Offline EMCD

    • Full Member
    • ***
    • Posts: 849
    RPM SB intake
    « on: August 15, 2012 - 10:11:11 PM »
    Does this intake have the cross overs that help with cold starts? If so, how do you block them?
    Logged


    Offline Chryco Psycho

    • Administrator
    • C-C.com Guru
    • *****
    • Posts: 36620
    • 70 Challenger R/T SE 70 tube Chassis Cuda now sold
    Re: RPM SB intake
    « Reply #1 on: August 15, 2012 - 11:29:32 PM »
    The RPM does , the RPM air gap does not , so if you have not bought it yet buy the air gap .
     If already have the intake you either need a thin piece of stainless steel or cut a section out of the old intake gasket if it is a steel lined one & silicone a patch into the new gasket e
    Logged

    Challenger - You`ll wish You Hadn`t

    Offline msbaugh

    • Sr. Member
    • ****
    • Posts: 1148
    Re: RPM SB intake
    « Reply #2 on: August 16, 2012 - 01:01:50 AM »
    I bought the regular rpm Manifold right before the air gaps came out! I was pissed that they didn't get it out a couple months sooner!  :banghead:

    Some metal valley treys for the big blocks have block off plates for the cross over. Mine hasn't burned up a hole through it yet so I think it's safe to say that as long as its a good quality metal piece it'll do ok for blocking it off.
    Logged

    Offline Chryco Psycho

    • Administrator
    • C-C.com Guru
    • *****
    • Posts: 36620
    • 70 Challenger R/T SE 70 tube Chassis Cuda now sold
    Re: RPM SB intake
    « Reply #3 on: August 16, 2012 - 08:34:19 AM »
    Sorry if yours is a big block , the 1214 for B engines & the 1215 for RB will work
    Logged

    Challenger - You`ll wish You Hadn`t
    Pages: [1]
    « previous next »