1970 Cuda "Crush Can"

[Ca70Cuda]

Hello, I just installed a "Crush Can" on my 1970 Cuda. I made sure that the "Crush Can" was keyed properly with the double spline before installing. After the splines were lined up, I installed the "Crush Can" and tightened. However, after the "Crush Can" was tightened down, there is a gap between the bottom of the "Crush Can" and the steering column housing that supports the ignition switch. I do remember seeing a gap in other Cudas that have a "Crush Can".

OK, Here's my question: What is the typical (Average) distance of the gap between the bottom of the Crush can" and the steering Column housing?

I have attached a picture as a reference. Please note that I really tightened this as much as possible. I even removed the "Crush Can", re aligned the splines and reinstalled. Still have a gap.

Thank you!   

[67vertman]

I just measured mine, it factory original, as-in never been removed, it measured 1/4 inch gap. 

[Ca70Cuda]

Thank you! I do appreciate this. I will measure the gap later today. I think it is about 1/4 inch or maybe a little bigger. Thanks again! 

[MEK-Dangerfield]

Mine looks like your picture.   

[Ca70Cuda]

Thanks for your assistance. Good to know the gap is normal. I measured the gap this morning and it was just under a quarter inch so I think I am in the ball park. Thanks for all the help.