Great pics of hot chics.
This is your thread Drew... Do you have any interior mods done to your Challenger? What motor do you run? Do you have a build thread?
I was also wondering if Dodj had finished installing his and how it turned out.
OK then there are pics in the beginning showing how it can be done with relative ease the dimensions are about the same except for the sides need to be cut and with the use of a heat gun,
And yes I have a few mods inside R/T logos embossed in the head rests and door panels, and out , 440 auto ,aluminum heads,different rear gears depending on what track and what road trip currently 3;23,s.
Tubular UCA,S reinforced LCA,S,reinforced K frame, adjustable aluminum strut rods,slotted crossdrilled Wilwoods on all 4 wheels,17 x8 inch wheels with 275 45 /17 tire,Qa1 adjustable shocks,
Here is a recent track vid
I post this cause the spoiler works if you watch the vid in the end you can see the front of the car stays down ,before the front of the car would raise up and effect the handling ,keeping air from going under the car is important especially with these cars .
one only has to look at the ole Vanishing point movie and you can see the front of the car is higher than the rear in the high speed shots.......so this spoiler does work it is just not stock,and if you look at the pics this can be done with out any major mods except for a few holes in the bottom of the valance
