3 piece cuda tail panel moulding install question

[barryv]

hi,does anyone know where I need to drill holes to install the 3 pieces of tail panel moulding for my 1972 barracuda  as well as were the clips go into the moulding. my barracuda never had them and I would like to install them.thanks

[Travis72]

From what I remember, at least on the side pieces that the hole location is not super critical.  The trim clips move inside the trim so you can position them where you want them.  Here's some pictures of my 72, this might help.







Travis
72 Cuda

[anlauto]

The corner pieces as stated above don't really matter. If I remember correctly the trunk lid has indentations along the inside of the rear lip that sort of indicate where to drill the holes. Just center up the holes in the trim area.

[barryv]

thanks,very good info

[barryv]

can someone tell me how the plastic clips that go into the long trunk lid moulding mount. I bought new clips ,but they don't seem to fit.thanks

[anlauto]

You place the round end in the hole then hammer the pins in.

[barryv]

thanks