Need help with where these insulation pieces go

[usraptr]

I'm in the process of putting the insulation back under the dash of my '70 'Cuda.  I've got most of it back in but I neglected to mark down where these three pieces went and can't figure it out.  Any help would be greatly appreciated as to where they go.
Thanks in advance.
Brad

[HP_Cuda]

The pieces go behind the heater box and the drivers side air vent

[shoooter]

How do they go on? Clips?

[Skunkworks Challenger]

They are fastened by plastic nails (pins) that push into holes in the firewall.

[HP_Cuda]

Those pins are a pain in the butt.

You need to be careful when pounding them in as they break easy, then you get to start all over again.

 

[usraptr]

HP_Cuda, are you sure?   I already have insulation pads in those areas and don't see any room for additional pads.  Please see attached pics. I was thinking maybe over the access holes to the door hinges in the "A" pillars, see pics?

[burdar]

Check and see if they fit on the back side of the kick panels.

[HP_Cuda]

Yeah I went back and looked at mine, they do look like kick panel insulation pieces.

Haven't stuffed mine in yet, have to still stick the dash in.

 

[usraptr]

The larger piece definitely goes behind the passenger kit panel and covers the hold in the A frame where you access the door hinge bolts.  When I dug out my driver's side kick panel it already had a insulation pad on the back side to cover the A frame hole on the driver's side so I'm still trying to figure out where the other two smaller pads go.