Author Topic: 8 3/4 YOKE SPLINES (Read 614 times)

crewchief · « **on:** June 26, 2014 - 10:09:14 AM »

Does all fine spline 8 3/4 rearend yokes have the big u-joint? If i have big u-joint yoke can it be adapted to smaller driveshaft joints. I see mopar performance has some type of kit.

Moparal · « **Reply #1 on:** June 26, 2014 - 10:25:16 AM »

yes it can, any parts house usually carries them. 7260/7290 very common Ususally you can tell them big / little joint. Car Quest part number is 2-0527

Katfish · « **Reply #2 on:** June 26, 2014 - 10:34:48 AM »

crewchief · « **Reply #3 on:** June 26, 2014 - 11:51:56 AM »

Thanks for the info!!!

burdar · « **Reply #4 on:** June 26, 2014 - 11:53:55 AM »

Quote

Does all fine spline 8 3/4 rearend yokes have the big u-joint?

No. I've got three 8 3/4 center sections. Two are the 489 case and one is the 741 case. All have the fine spline yoke. All take the small U-joint.

Chryco Psycho · « **Reply #5 on:** June 27, 2014 - 12:00:14 AM »

I agree small or large U joint yolks are available in 29 or 10 spline but it is fat easier to use a conversion joint instead of swapping the yolk , on a 489 this can destroy the gears if the crush sleeve is not replaced & torqued properly

Author Topic: 8 3/4 YOKE SPLINES (Read 614 times)

crewchief

8 3/4 YOKE SPLINES

Moparal

Re: 8 3/4 YOKE SPLINES

Katfish

Re: 8 3/4 YOKE SPLINES

crewchief

Re: 8 3/4 YOKE SPLINES

burdar

Re: 8 3/4 YOKE SPLINES

Chryco Psycho

Re: 8 3/4 YOKE SPLINES