Moroso Fabricated Valve Covers

[Mopar Thunder]

I'm looking to change my valve cover bolts but I'm having a hard time finding any that fit down the tube area on the Moroso valve cover. Has anyone had any experience with this and if so any suggestions on what to use?  Not sure if a stud set up will work with a nut.  Thanks in advance

[burdar]

Picture of the cover? 

[Chryco Psycho]

Probably Allen / hex drive

[Mopar Thunder]

Here is a pic of the valve cover. The issue is the tube size on the rails. I can't find a bolt head that will fit.  Chryco I think you might be right. If I could find an Allen or hex bolt to fit.  The welds also might be getting in the way. I was hoping someone had run into this already.

[burdar]

Yes, typically an Allen head fastener is used with those covers. Your local hardware store might have something. If not, I'm sure Summit or Jegs will have them.

[4Cruizn]

Yep . . check your local hardware store!  I have one by me that has a huge amount of nuts and bolts and I found some there . . .

[Mopar Thunder]

There is a pretty good hardware store a few towns over I 'll try that.  I didn't see anything in Jegs but I might have been missing them.  Thanks 

[MOPAR FANATIC]

  These may work  moroso#710-68550=====  1/2 x 3-7/8 crome 4 pak

[Mopar Thunder]

Thanks Mopar Fanatic,

These are an option.  I do want to get rid of the "T" handles.  I did find some Allen head bolts and washer that fit in Black Chrome at a hardware store which look pretty good also.