Cast crank and stock rods?

[TelisSE440]

I wonder the same, will the stock parts handle it ?

[RCCDrew]

Found a good article on angle milling the heads. Sounds like it is a lot of work, but also a lot of benefit.

http://www.hotrod.com/how-to/engine/ctrp-0312-angle-milling-cylinder-heads/

[TelisSE440]

Found a good article on angle milling the heads. Sounds like it is a lot of work, but also a lot of benefit.

http://www.hotrod.com/how-to/engine/ctrp-0312-angle-milling-cylinder-heads/

Nice read!