cuda door and 1/4 window glass, location when making conatct w seal

[culp71]

looking for some insight as to where the door glass and 1/4 glass should be when up, in reference to the window door jam seal, pictures would be the best.
Especially the 1/4 glass where the stainless vertical trim on leading edge of 1/4 window should touch on the seal ,how far up and in or out on seal should it be set.

[73_Cuda_4_Me]

 

Not sure if 73 is same as a 71, but this should give you an idea...!

 

[culp71]

that helps a lot!
it appears I have all my glass set much shallower on that seal, back to tweaking.

thanks!

[culp71]

alright, I readjusted all my glass so that it appears to be similar to the picture posted, one question in doing so though...since the door swings closed the glass falls on the outside kind of compressing the seal to the side, should it fall above ,below or  at the seal seam flap?
Then because the 1/4 rolls up to the seal, should the rear and top edge of glass fall into the flap /slot in the seal? or just push up to it?
also the rear rail that the rear edge of the 1/4 glass slides up and down in, that channel has a screw in the top and a clip at the bottom, the bottom lines up with a bracket welded to the fender well, does this just clip over it and is allowed to slide in and out or should it be fastened somehow?