Hey guys, am currently putting a 4 speed setup in my 70 cuda, at the stage where I am welding in frame cons, torque boxes, new 4 spd tunnel, etc. Before the car goes to the sandblaster I want to mount the frame pivot bracket for the clutch. I just ordered a new one from Brewers but don't know how to make sure it is in the right spot??? The car has a small block with bellhousing and trans in it right now that I am using to mock up. How do I make sure the frame pivot bracket is in the right spot, anyone have any measurements for me??? I don't have a Z bar yet as I am not sure which bellhousing I will be using down the road. Anything else I should be welding in now for the 4 speed conversion? Thanks, Tyler