Carb Setting and Adj. (426 Hemi)

[gcone]

I need some advice on setting my carbs (426 Hemi).  The car came from Wyoming, where I would assume it would have been jetted for around 5-6000' altitude. I am in Minnesota, and we are at 2000'.  The car is running very rich. Anyway...

First off, I thought they should be Carter 4139 and 4140 carbs. The numbers I took off them were:
--Front: F39635S
--Rear: 2H49635S.  Does this make sense to anyone?  If I decode this correctly, (thankx to an old thread by Hemi71!) they are Carter 9000 series and 625cfm; but for a Chevy...not
  the 875cfm that the car came with.
If that is the case, what is the proper jetting, rod size and bowl setting?  I have changed the jets to the factory recc: which is:
--Front: 89.089 both primary and secondary
--Rear: Primary-89 (both left and right)
          Secondary-92 left, 77 right
What size metering rods should be used?...and the float setting?  Thx in adv. for hte help.

[Chryco Psycho]

I do not have the specs handy , sould be listed on the internet from the carb #s though , I would check the float levels first

[gcone]

Thx, Chryco.  After extensive digging, I found this website-the pdf is the detailed service manual for all Carter AFB Performance Series Carbs. 

http://www.federal-mogul.com/fmeconnect/technicalservices/downloads/1601.pdf