Author Topic: Is it normal for sure grip to make clinking noise?  (Read 1278 times)

Offline challengermaniac

  • Full Member
  • ***
  • Posts: 891
Is it normal for sure grip to make clinking noise?
« on: September 01, 2006 - 05:56:15 PM »
Hey guys (and gals if there are any of you out there), I have a 1974 Challenger with a 3.23 sure grip rear end.  I notice when in forward or reverse at very low speed (like less than 1 mile per hour) and especially when turning, I get a clinking feeling, noise and actually see the rear wheel girate a little.  Is this normal;  ie. does it just do this because one wheel is turning faster/slower than the other, or do I have a potential problem?  Thanks everyone.  Charlie   
Charlie
70 Challenger 340/4 Purple
70 Challenger T/A Red
Edmonds, WA




Offline Chryco Psycho

  • Administrator
  • C-C.com Guru
  • *****
  • Posts: 36620
  • 70 Challenger R/T SE 70 tube Chassis Cuda now sold
Re: Is it normal for sure grip to make clinking noise?
« Reply #1 on: September 01, 2006 - 06:04:08 PM »
sounds like a problem , is the end play set properly in the diff ?

Challenger - You`ll wish You Hadn`t

Offline jeryst

  • Resident
  • *****
  • Posts: 2032
Re: Is it normal for sure grip to make clinking noise?
« Reply #2 on: September 01, 2006 - 09:58:38 PM »
Sounds dumb, but did you check for proper fluid level in thje rear end? Either way, I wouldn't drive it until you have it checked out, because you might wind up throwing an axle. Bad news at any speed.

Offline 426 pentastar

  • Jr. Member
  • **
  • Posts: 175
Re: Is it normal for sure grip to make clinking noise?
« Reply #3 on: September 02, 2006 - 06:16:11 AM »
sounds like your axle end play or your sure grip has a problem,i would adjust your end play and try it :working:

Offline FM3V6M

  • Full Member
  • ***
  • Posts: 738
  • TX9 383 4spd
    • mytx9cuda
Re: Is it normal for sure grip to make clinking noise?
« Reply #4 on: September 11, 2006 - 08:06:19 PM »
Clunking noise, particuarly when turning could just be low fluid level.

Offline oldkimmer

  • Jr. Member
  • **
  • Posts: 244
Re: Is it normal for sure grip to make clinking noise?
« Reply #5 on: October 27, 2006 - 11:37:58 PM »
u are possibly starting to have a problem, but u can prolong it by changing the oil and adding the friction modifier, this will allow the clutches/cones to slip when going around turns.
The beast has been unleashed........Thems the hazzards..........Unleash the beast......

Offline 1973_Challenger

  • Jr. Member
  • **
  • Posts: 35
  • You Don't Know What You Don't Know
Re: Is it normal for sure grip to make clinking noise?
« Reply #6 on: December 07, 2006 - 02:32:44 PM »
I had the same problem with mine during the restoration. I changed out the rear end with a 489 case and did not add the friction fighter after adding the fluid because the auto store was out. The problem would occur just pushing it into and out of the garage. After adding the friction fighter, the problem went away.