72-74 challenger cuda rallye dash setup

[74chall]

350$
Switch panel is good with switches,no cracks. All light tubes and seat belt,oil etc lenses are there. All gauges are there but need to be restored. The plastic bezzle has a half inch crack on the top side. Would be good to send out and get redone for your car,beings most of the nicer ones need to be calibrated regardless.   

[4Cruizn]

Dammn looks like another 2 speed wiper switch.   

[74chall]

I bet i have a 3speed one around here somewhere

[4Cruizn]

I bet i have a 3speed one around here somewhere

             


You wouldn't happen to have any 440 motor mounts too would ya?   

[TreeFrog]

how bout a light tube or two?

[74chall]

no, i dont sorry. I believe mine is misisng a light tube in the lower center....never noticed that until i looked at the picture.

[TreeFrog]

is there any tube for the lower section?  I was thinking there were only the three at the top..

[MEK-Dangerfield]

is there any tube for the lower section?  I was thinking there were only the three at the top..

There are only 3 at the top. It looks like one would go on the bottom, but there is no need for one there. 

  Mike

[74chall]

last call before it hits egag   

[DAYLEY/CHALLENGER]

My speedometer looked like that one. I found the end of the pointer in the dash assembly and glued ti back to the other part.  So far so good.

[74chall]

Sold on ebay to the 4th person who looked at the auction..guess i sold it too cheap