What's this hole?

[ksierens]

I am restoring my 70 Challenger R/T and I am trying to figure out if the hole in the picture, next to the 4 speed support backet holes, should be welded up.



http://mywebpages.comcast.net/ksierens/

[Stacked440]

Dunno...I don't believe that is on mine.  Don't weld it up on my hunch though   My car isn't here at the moment so I can't tell you for sure

[Stacked440]

Well, found some info on that hole for you, that is the clutch safety switch hole for a challenger.

[ksierens]

Thanks! Great picture!

[ragtopdodge]

Anyone know what these are for?

[Wang]

Thanks Stacked440 for the pic!!  Saved it for my archive & future reference.  Very cool. 

[ksierens]

Ragtopchally, those are for the retainers for the firewall insulation used on the inside of the car.

[ragtopdodge]

Ragtopchally, those are for the retainers for the firewall insulation used on the inside of the car.

THanks.  That's on the firewall.

What about the lower ones?

-r

[ragtopdodge]

bump!

 

[ksierens]

Hmmm, nothing I can think of.

[dougs bs23]

Had to print the orange pic for my own reference,,, so now the ? is,, anyone have a pic of the other half showing cutouts for a/c?   I measured one up that had 3 1-1/4" holes on the bottom under the blower, one is for the blower vent, one for the drain tube, but whats the 3rd hole for?

[purple1]

I measured one up that had 3 1-1/4" holes on the bottom under the blower, one is for the blower vent, one for the drain tube, but whats the 3rd hole for?

You measured my orange car when I gave you the a/c box right? I though I told you the third hole is for the vacuum line.

Dave