Author Topic: front end problem ??  (Read 1374 times)

Offline mopower

  • Jr. Member
  • **
  • Posts: 265
front end problem ??
« on: July 19, 2007 - 05:02:27 PM »
 :dunno:i appreciate any and all help... my front driver fender bounces up and down pretty good like its loose. it isnt. driver front tire when you hit a few concective bumps acts likes the fender up and down quik like somethings loose or not aligned properly. have had it aligned three times in a month, the say its dead on.front end is all completly new..everything. ive tightend everything i could think of..im stumped ?????




Offline MEK-Dangerfield

  • C-C.com Expert
  • ********
  • Posts: 20946
  • I don't get NO respect! Member since 1/25/2002
Re: front end problem ??
« Reply #1 on: July 19, 2007 - 05:15:28 PM »
Could the tire be out of balance? Try switching front tires, and see what happens.


  Mike

Mike

1970 Challenger - SOLD
2016 SXT+.  1 of 524 SXT+'s in Plumb-crazy for 2016.

Offline Bullitt-

  • Permanent Resident
  • *******
  • Posts: 12167
  • Better Things To Come Member Since 2/16/06
Re: front end problem ??
« Reply #2 on: July 19, 2007 - 05:31:36 PM »
is it possible that you have a Right side torsion bar on the Left(drivers) side...heard that creates some issues.
Wade  73 Rallye 340..'77 Millennium Falcon...13 R/T Classic   Huntsville, AL
Screwed by Photobucket!

Offline mopower

  • Jr. Member
  • **
  • Posts: 265
Re: front end problem ??
« Reply #3 on: July 19, 2007 - 06:00:52 PM »
are the torsion bars marked ? and thank you for the replys

Offline JayBee

  • Resident
  • *****
  • Posts: 2477
Re: front end problem ??
« Reply #4 on: July 19, 2007 - 06:05:34 PM »
Yes, the torsion bars should have an "L" and an "R" stamped into the end. Mine were reversed once but never experienced any "bouncing" that you're talking about. I just couldn't get any height out of the front end, but that was only my experience.
John

1970 Barracuda convertible
2014 Toyota Avalon

Offline 360 'CUDA

  • Sr. Resident
  • ******
  • Posts: 5784
Re: front end problem ??
« Reply #5 on: July 19, 2007 - 06:06:58 PM »
My guess is you broke a shock but it's hard to say without inspecting it

Offline mopower

  • Jr. Member
  • **
  • Posts: 265
Re: front end problem ??
« Reply #6 on: July 19, 2007 - 08:34:52 PM »
thanx everyone for the imput

Offline Chryco Psycho

  • Administrator
  • C-C.com Guru
  • *****
  • Posts: 36620
  • 70 Challenger R/T SE 70 tube Chassis Cuda now sold
Re: front end problem ??
« Reply #7 on: July 20, 2007 - 01:06:49 PM »
I agree , Bad shock or the tire is out of round , I have seen BFG tires with less than 600 miles on them that were 1/4" out of round

Challenger - You`ll wish You Hadn`t

Offline IMNCARN82

  • Resident
  • *****
  • Posts: 3547
  • LeDZeP
Re: front end problem ??
« Reply #8 on: July 22, 2007 - 10:31:24 AM »
I know you got an alignment ...but have you taken it to a good  frame shop?  Had it straightened out? Checked? :dunno:   
'73 340 5 speed,RMS,BAER,... "Supercuda" (O[   ]||||[   ]O)  
'69 Dodge Charger 383,Auto                  (OiiiiiiiiiiIiiiiiiiiiiO)
13' Challenger R/T BlacktoP  6spd. (OO________OO)
71' Demon
75' Duster
87' Conquest TSI
56' Plaza
Boulder CO
Robert    "cuda bob"

Offline LAA66

  • Sr. Member
  • ****
  • Posts: 1669
Re: front end problem ??
« Reply #9 on: July 22, 2007 - 11:24:44 AM »
 Did you mean the fender itself is the concern? Mine moves a bit as we drive down our dirt road. Seems like additional bracing is needed.

Offline 360 'CUDA

  • Sr. Resident
  • ******
  • Posts: 5784
Re: front end problem ??
« Reply #10 on: August 20, 2007 - 11:59:43 PM »
Any update??

Offline moper

  • Resident
  • *****
  • Posts: 2368
Re: front end problem ??
« Reply #11 on: August 21, 2007 - 12:08:56 PM »
Sounds like bad/broken shock. I hate doing struts, and both my Omni, then my Neon would the the same things until I replaced them. New doesnt always mean good.