challenger 4 speed.....

[challenger71]

Could anyone out there tell me how to take apart my 4 speed shifter? I have never done it and don't want to wreck it. Do they make a rebuild kit for it? I have the bottom chrome piece off and the side plate, but I am not sure how to get the 3 "arms" out. Any help would be appreciated.

[matt63]

I'm looking at doing this in the winter too.  I think there is a pressed in tube that has to be removed to get the shift levers out.  I'm not aware of replacement parts being available but perhaps someone knows better.  I was just going to clean and grease the plates.

[Chryco Psycho]

Hurst used to sell parts , but since they were bought by mr gasket it is tough to get much for them
 you do need to remove the 3/8 nut from the cross pin at the top of the shifter & remove the plate it holds on & slide the tube out of the upper pivot then just clean & grease all the parts

[challenger71]

Got a trick for sliding that pin out? I have everything else done.

[Chryco Psycho]

Usually it is not hard to remove , try a tapered punch from the outer face to see if it releases that way