Splash guards?

[Katfish]

Not sure if this is the right name.  It's the plastic part that bolts to the frame rails on the front end (front of passenger tire). 

Any 70-74 E-body will work.  The pic is the part needed.

Thx

[Bullitt-]

There are reproductions available...

the two L&R forward.

http://cgi.ebay.com/ebaymotors/MOPAR-Splash-Shields-70-71-Cuda-Challenger-NEW_W0QQcmdZViewItemQQcategoryZ34200QQihZ011QQitemZ320039638246

the starter shield

http://cgi.ebay.com/ebaymotors/1970-74-NEW-Cuda-Challenger-Starter-Splash-Shield_W0QQitemZ120205665859QQihZ002QQcategoryZ34204QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

and the two flat ones to the rear

http://cgi.ebay.com/ebaymotors/70-4-Challenger-Barracuda-Splash-shield-kt_W0QQitemZ260200757442QQihZ016QQcategoryZ6763QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

[Katfish]

The starter shield is the only 1 that looks familiar.  I need the passenger side, these are bolted to the frame.  The 1st ebay auction pic looks different and is riveted.

I'll try to post  a pic.

[73EStroker]

Hey Katfish - bullitt is correct. You need the little rubber flappy one for the rear of the passenger side and the one in the picture you posted for the front right. I was getting the rubber ones yesterday from a local (in Calgary) Mopar dismantler. I still need the front right but will just buy a repro. Gotta get this thing going soon!!!! Also I learnt that the B body 71-72 rubber flappy things are the same as well.

[Katfish]

Boy, I'm really confused.  Aren't the rubber pieces removeable when adjusting the upper control arms.  There are 2 of these on each side right near the UCA bolts?  These are mounted to the fenderwalls.

I need the hard molded plastic pieces that bolt to the frame rails and hand down toward the ground.

[Bullitt-]

Only one side hangs down, on the drivers side is the starter shield nothing on the passenger side...correct about the rubber pieces. 

[Katfish]

Thanks for clearing that up, anyone have the hard plastic part for the passenger side?

Thx