Author Topic: Opinion wanted on business idea  (Read 1554 times)

Offline GoodysGotaCuda

  • Sr. Resident
  • ******
  • Posts: 5392
Re: Opinion wanted on business idea
« Reply #15 on: May 25, 2008 - 10:42:04 AM »
Not sure if it has been covered but as far as running FWD cars on a dyno, when they really do put some power down it can be dangerous. Torque steer can walk the front of the car straight off the rollers. Also add that manual transmissions like to snap whenever someone 'drops' the clutch on the dyno. Just things to consider as far as letting owners run their own cars, there are many 'not so smart' hot rodders out there that may end up looking to you for why they're car took off or they're input shaft snapped. Also you'd have to make sure you strapped the vehicles down and set them up right if anything, thats another thing i've seen some hairy things done! Dont forget the big AWD crowd...those dynos are big $$$, depending on the car scene where you are, it may or may not be worth it.
Build Page: Goody's 'Cuda Build Page
1976 Dodge Warlock
1972 Barracuda - 5.7 Hemi + T56 Magnum

Wheel & Tire Specs:Link




Offline loco340cuda

  • Full Member
  • ***
  • Posts: 819
Re: Opinion wanted on business idea
« Reply #16 on: May 25, 2008 - 07:11:47 PM »
Everyone, thanks for all the feedback.  I always think it is good to throw out an idea to a crowd such as you guys on the board.  People bring different experiences to the table and have brought up some things that I haven't thought about. 

Reading into you guys input I would say that the collective thinking of all the posts is that it would be difficult to make money with a dyno only business, or at a minimum it would be a really risky investment.  So at this point I think I'll go back to the drawing board of ideas and think about another business. 

Thanks again for all your input.   :thumbsup:
1970 Cuda 340 4-speed - now stroked to 416ci (SOLD)
2017 Mustang Shelby GT350

Offline HP2

  • Resident
  • *****
  • Posts: 4478
Re: Opinion wanted on business idea
« Reply #17 on: May 26, 2008 - 11:33:31 AM »
Have you looked in the phone book to see if such types of shops exist in your area already?

Have you priced out the equipment? Not just the dyno but the diagnostic equipment, etc.

What is the local rates per square footage for business space?

Offline ntstlgl1970

  • Resident
  • *****
  • Posts: 2204
  • T a c o c a t
Re: Opinion wanted on business idea
« Reply #18 on: May 27, 2008 - 12:25:41 AM »
Have you looked in the phone book to see if such types of shops exist in your area already?

Have you priced out the equipment? Not just the dyno but the diagnostic equipment, etc.

What is the local rates per square footage for business space?


:iagree:

Also I would add, take a business class at your local community college. That would be your best investment. You may run through a business plan and after doing your market research, find out that it is not a good idea (economically feasible). Better to find out in class than in the real world.
70 Cuda, 7.0L Gen-III Hemi, Viper T56 w/9310 gearset, 3.91's, Megasquirt MS3x v3.57, Innovate wideband, Firm Feel upper arms, torsion bars, springs and strut rods, QA1 DA shocks. I did everything on this car except the fancy paint stuff and I drive it...and I can't seem to stop messing with it....