440 Source Roller Rockers (Sale Pending)

[nivvy]

440 Source 1.7 Ratio Roller Rocker "Full Rollers"

Less than 100 miles on them since installed.. my k motion springs are too big for these and my spring pressure is also to high for the rockers...

Was $260 new I believe and you cant get 1.7's anymore...I am going to clearence them for spring clearance but I have large diamter springs so im sure yours wont be a problem also...

Comes with 1 extra shaft and spacers.. hold downs not included... but can be had for an additional $70 and they are Mopars and $100 new..



Rockers / Spacers & extra hardened shaft and extra adj. screws and nuts    $170
Hold Downs w/bolts                                                                            $70
Shipping                                                                                           $15

If your lobe lift is lets say .350 all you do is multiply by 1.7  (.350 * 1.7) would give you .595 lift at the valve...

 

[nivvy]

$220 to your door takes it all... u.s. only....... 

[nivvy]

$215 to your door takes it all... u.s. only....... 

[nivvy]

$210 to your door takes it all... u.s. only.......  ths is a steal....

[nivvy]

I compltely forgt to mention I have the pushrods I used for the iron head setup... they were about $100 and will sell for only $40 additional..... 

They are comp camspush rods.......

you also get extra shaft(new) and adjusters and nuts (new)...

let me double check the price on the rods to b sure....

[nivvy]

http://store.summitracing.com/partdetail.asp?part=CCA%2D7442%2D16&autoview=sku

$115