Bought some good parts today for my stroker

[Moparal]

I am getting ready to build me an eight mile car.  I went to visit a friend today and he gave me a very good deal on these parts listed

complete untouched 72 400   
4.15  499 source crank     New in box
milodon gear drive  almost new    10 1/4 mile passes on it
dana 60 complete  (Truck) to be narrowed
2 inch hooker headers. used but very useable

So I got a very good start for my new project.

I need to get some rods, pistons, and a good set of heads. I have a roller cam already.  I want the compression close to 15-1. Planning on 3000 lb car.  Ladder bar rear

[BIGSHCLUNK]

Alan , better pull that belt tight and hang on!!   

[71chally416]

The guy next to my shop bought my old B-1 heads and he mentioned to me they were for sale. Pretty radical. Raised port - floors filled with epoxy. They were on a 499 stroker motor. I think he still has the Intake too. If you're interested I'll ask him what he wants.

[The Cuda Guy]

SWEET!!!!      

What are you too old to go the whole 1/4 mile???   

Don

[sleepychallenger]

SWEET!!!!     

What are you too old to go the whole 1/4 mile???  

Don

[nivvy]

I am getting ready to build me an eight mile car.  I went to visit a friend today and he gave me a very good deal on these parts listed

complete untouched 72 400   
4.15  499 source crank     New in box
milodon gear drive  almost new    10 1/4 mile passes on it
dana 60 complete  (Truck) to be narrowed
2 inch hooker headers. used but very useable

So I got a very good start for my new project.

I need to get some rods, pistons, and a good set of heads. I have a roller cam already.  I want the compression close to 15-1. Planning on 3000 lb car.  Ladder bar rear

Cheater.... Pump Gas only 

[sleepychallenger]

Cheater.... Pump Gas only 

does it count if he pumps the gas from his can to the tank?

[nivvy]

15 to 1 compression and a gutted 3000lb challenger... thats not a street car alan.... 

Man your gonna fly by oldschool  .... If that is what you are really building then I need a 250 shot equalizer 

[The Cuda Guy]

Cheater.... Pump Gas only 

 

[73EStroker]

Al - take a look at the bearing housing ends supplied by DTS www.drivetrainspecialists.com. You weld them in once you have the diff narrowed from PU truck dimensions. They make them to fit the Ford Truck sealed taper roller bearings. Much stronger setup than the green bearings which I have and will most likely regret. Mind you - I have not seen a Ford wheel c/w axle floating down the road lately. The setup I mention from DTS saves you the hassle of trying to fit the floating center pin in the Dana gearset and still gives you lots of strength for the corners.

[wally426ci]

I am getting ready to build me an eight mile car.  I went to visit a friend today and he gave me a very good deal on these parts listed

Al, my car was an 8 mile car when I first bolted it together before paint, I made it 8 miles and the radio started smoking